You can now process any input that the sound card is capable of handling, and send your processed audio to the same sound card's outputs, locked to the same sample rate. Set your DSP application's destination(s) to be the sound card's analogue outputs (or SPDIF). Set your DSP application's source to be the same sound card's input, and select whichever input you want ('Wave', SPDIF etc.) if you have the choice, or the simply the sound card's mixer as the source. From now on, any standard media player will route its audio to the sound card's 'Wave' input, and you can also take in SPDIF or analogue line in if you want. Set the Control Panel->Sounds and Audio Devices->Audio->Sound playback->Default Device to be the sound card in question. Once you have turned off the sound card's internal routing, the setup for bit-perfect grief-free active crossover (in Windows at least) is as follows: You can also turn off any internal routing - which is what you need for DSP processing. The card's standard drivers allow you to connect any input to any output with a sort of matrix arrangement. The more up-market Creative X-Fi can work at a variety of sample rates in 'bit perfect' mode, and its re-sampling (should that be necessary) is supposedly very, very good anyway. Unfortunately the Audigy always re-samples internally to 48kHz, reputedly not particularly well - although it sounds OK. However, the open source Kx Project drivers allow you to turn off this internal routing. The Creative Audigy, for example, seems to do this unavoidably when you're using the Creative drivers. The problem, as far as I can tell, is merely that the default routing of most sound cards is to connect any incoming stream internally to the analogue outputs. I'd like to know which cards make it possible, and which don't. As I understand it, this thread exists because people need to route audio from any source (SPDIF, CD, Windows media player, Spotify, Youtube) via DSP-based processing and finally out to their speakers, and it isn't immediately obvious that this is possible without resorting to two sound cards linked by SPDIF (jitter, re-sampling), or 'virtual audio cables' (re-sampling).įrom my limited experience it is possible to do exactly what they need using only a single sound card and nothing else, although it isn't possible with all sound cards.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |